The vehicle controller endurance testing system has basically reached the last part of controller development. It is one of important auxiliary tools for the controller development. All the hardware and software functions of the controller need to be tested and verified by this system.
The control system needs to meet all the input and output functions. The performance is slightly higher than the electrical performance of the controller under test. At the same time, it can simulate the injection of the related hardware faults. The software design monitors and controls the signals and parameters of the test system in a convenient and intuitive way.
Usually, the control system consists of a programmable power supply, power control box, system display, switch box, load box and signal excitation module (NI).
The load box is used to simulate all signal conditioning and load modules of the controller to provide various load characteristics required by the driver of the controller. At the same time, the signals of the signal excitation device are input to the ECU, and then through the data acquisition device such as NI The signal is collected back to the host computer software for data analysis. The general control of time is in 2000H. If there is a problem of intermediate data collection, you need to re-open the experiment, and record the corresponding data to form a report.
At present, Strong can provide the durable test systems based on the domestic mainstream controller manufacturers, and also the special controller.
The vehicle controller endurance testing system has basically reached the last part of controller development. It is one of important auxiliary tools for the controller development. All the hardware and software functions of the controller need to be tested and verified by this system.
The control system needs to meet all the input and output functions. The performance is slightly higher than the electrical performance of the controller under test. At the same time, it can simulate the injection of the related hardware faults. The software design monitors and controls the signals and parameters of the test system in a convenient and intuitive way.
Usually, the control system consists of a programmable power supply, power control box, system display, switch box, load box and signal excitation module (NI).
The load box is used to simulate all signal conditioning and load modules of the controller to provide various load characteristics required by the driver of the controller. At the same time, the signals of the signal excitation device are input to the ECU, and then through the data acquisition device such as NI The signal is collected back to the host computer software for data analysis. The general control of time is in 2000H. If there is a problem of intermediate data collection, you need to re-open the experiment, and record the corresponding data to form a report.
At present, Strong can provide the durable test systems based on the domestic mainstream controller manufacturers, and also the special controller.